Fitting The Vent Opener Step 2

If this was a traditional vent the angles would have been much simpler bends. I cut off a section from each end so that there. Cutting a hole through the plastic:

To Keep That From Happening Again, I Decided To Install An Automatic Bee's.

Web step 1 place the opener in the centre of a window vent and mark the position of the holes on the window frame and greenhouse frame. Attach the vent cover to the air duct: Web a few years ago a customer of ours made up some vent openers for their dome greenhouse and used our linear actuators to operate the vents.

Web The Rest Of The Braces Are Standard Steel Bar Stock That Are Bent At Slight Angles.

Web 2.1 step 1: Web almost killed some starts when i forgot to open the lower vent in the greenhouse. I basically attach the actuator to the window frame, i took a piece of angle iron and made a cross brace.

Because Of The Odd Angles Of The Dome, A Few Of Braces Need To Be Bent As Compound Angles.

If not, mark the position on the metal with a pencil and drill the holes in. There are four of them which go from the greenhouse struts to the back side of the actuator.